Evoqua DEPOLOX - Guarantee Conditions

DEPOLOX
®
Pool Safety Notes
WT.050.570.000.DE.IM.0714 9
NOTE
The safety instructions in the technical documentation for installed de-
vice components must also be observed!
Notes for
operating personnel
 Before starting operation of this device always read the operating
manual, in particular the safety instructions!
 Never employ any working methods which could endanger safety!
 Always comply with the prescribed values for sample water admis-
sion pressure, connection voltage and ambient and operating con-
ditions!
 Never deactivate any safety features!
 During operation of the device there is the risk of unexpected in-
correct functions resulting from failure or errors of the control sys-
tem.
In the event of such safety-relevant changes in the operating per-
formance of the device, switch it off immediately and remedy the
fault or have it remedied immediately!
 When the device is switched off, external voltage may still be ap-
plied.
 Always eliminate or have eliminated any leakage on the flow block
assembly immediately!
 In the event of a fire always switch the device off with the external
main switch or the external main circuit breaker or fuse!
1.1.5 Guarantee conditions
The following must be observed for compliance with guarantee
conditions:
 Installation, commissioning by Evoqua technicians or trained and
authorised specialised personnel, e.g. of contracted companies
 Conform to the intended use.
 The operation parameters and settings must be met.
 The system may only be operated by instructed personnel.
 A works journal must be kept.
 Use of approved calibration solutions
 The system should always be protected against frost.
 Execution of maintenance work by operating personnel
 Use of original spare parts
If any of the above conditions are not met, the guarantee is revoked.