DEPOLOX
®
Pool Operation
WT.050.570.000.DE.IM.0714 31
1.3
Softkeys
Indication of the current assignment of the softkeys.
Stop the adaption procedure.
Select one or more options from the list provided.
Change the operating mode.
Confirm your selection.
Select the "Calibration" menu.
Activate password protection.
Select a menu.
Select the "Mode" menu.
Start deactivation of password protection.
Move up one level.
A further sub-menu is available (e.g. when the DIN function is activated)
Feed delay
The time until dosing resumes after interruption.
Positioner feedback (Ym)
Feedback only applies for free chlorine.
To compensate for tolerances and possible positioner restrictions the
feedback display must be aligned.
Alignment can be performed either automatically or manually (refer to
the section 1.3.4 Calibration).
Sample water temperature
Error indication active (display bottom right)
The system has detected an error. The error can be specified with the
table in section 1.4. The number combination states the series number
of the error message and the total number of error messages (in this
case the first error of a total of five).
Display number (display bottom right)
This number enables allocation to a menu and stipulates the sequence
within the menu.
- - - - Blanks
Blanks serve to indicate when a value cannot be displayed (e.g. no sen-
sor measuring module installed).
To Next Page
Loading...
