DEPOLOX
®
Pool Installation / Commissioning
WT.050.570.000.DE.IM.0714 127
2.7
2.7 Installation / Commissioning
WARNING!
Only authorised and qualified electricians are permitted to install
the device and open the housing. The device may only be taken
into operation when the housing is closed, and must be connec-
ted to protection earth. Modifications to the device which go bey-
ond those described in this manual are not permissible.
WARNING!
The device is not equipped with a mains switch and is in operation
as soon as the supply voltage is applied. An external switch or cir-
cuit breaker is necessary. The conductor cross section of the
mains cable must be at least 0.75 mm² (AWG 18). Provide a mains
fuse locally (6 A).
When connecting system components (e.g. devices, motors,
pumps) as well as when entering operating data, the system com-
ponents must be switched off in order to prevent uncontrolled ac-
tivation or any incorrect function.
CAUTION!
To ensure safe and correct commissioning, knowledge of the operati-
on, connected electrical load, measurement signals, cable assignment
and fuse protection of the connected devices and machines and the re-
levant safety regulations is required.
Commissioning of the device may therefore only be performed by qua-
lified and authorised electricians.
Incorrectly connected devices can be damaged, possibly irreparably, or
cause faults in other equipment when they are switched on or in opera-
tion. Ensure that the measuring and control cables are not confused or
make contact with one another. Never connect or disconnect any ca-
bles to which voltage is applied!
To Next Page
Loading...
