32 WT.050.570.000.DE.IM.0714
Operation DEPOLOX
®
Pool
1.3
Dosing and alarm indi-
cation
LED The nine LEDs are another indicating element. The significance of the
eight red LEDs depends on the selected application. This determines
whether control output or alarm is selected. The significance is marked
on the labelling strip to the right of the LED. The green LED lights up
when the device is in operation (POWER).
General messages Adaption is running!
This message appears if an attempt is made during adaption to auto-
matically calibrate the positioner.
This function is possible in the manual mode only!
This message appears, for example, if an attempt is made to calibrate
the positioner during automatic operation. Acknowledge by pressing
ENTER or the ESC key.
A module was removed!
Do you wish to take over this configuration?
This message appears when the device is switched on after removal of
a module. Acknowledge with the yes/no key.
New hardware component found!
This message appears when the device is switched on after addition of
a module.
NOTE
Information on the plug-in cards which are contained in the device
are displayed in "Analog scan" when it is switched on or can be
viewed statically in the "Diagnosis" menu, item "Software Version"
(Display 1.8.5).
Operating elements
Softkey
Activate the function shown on the graphic display with the keys.
Up
Move up one level.
Display the previous option.
Increase the value.
Down
Move down one level.
Display the next option.
Decrease the value.
Left/right
Change the column in the menu.
Change the position in the displayed value (cursor menu).
Move forwards or backwards by seven hours in the line diagram.
To Next Page
Loading...
