Evoqua DEPOLOX - Page 63

DEPOLOX
®
Pool Operation
WT.050.570.000.DE.IM.0714 63
1.3
Diagnosis
(Menu 1.8)
Basic display Refer to main menu
Menu select Display of all available menus
Menu diagnosis Display of all available diagnosis displays
Diagnosis
(Cl
2
; pH; Redox;
Cl-N; Cond.)
Information on the existing measurement inputs
 Date and time of the last 5 calibrations
 zero  zero at calibration
 pH7  calibration offset at pH7
 DPD mg/l DPD at calibration
 Span/pH Signal span at pH calibration
 Offs.  Signal offset at pH and mV calibation
 act.  present sensor signal
 Span  Signal span at conductivity
Dosing average Display of the average dosing rates in % during the set period:
 hour  last hour
 day  last day
 week  last week
 month  last month
Diagn.
Inputs/Outputs
Information on
 the assignment of the mA outputs
 the current mA output in mA and %
 present dosing output Yout for Cl2, pH, conductivity in %
 CEDOX: Present calculated contamination of the pool water
 Remaining mV delay time until the CEDOX factor is checked again.
 The current switching conditions of the relays
Relay off
Relay on
 The selected application
 The send/receive condition of both interfaces RS485 and RS232
 The current switching conditions of the digital inputs
 Flocculation, DIN function On/Off
Software version Information on the software versions
 The sensor measuring modules in the slots 1 to 5
 The analog outputs card
 The main CPU
 The graphic display