Cityline Fingerprint
Ref.6959
Fingerprint
• Biometric access fingerprint reader with capacitive sensor.
Identifies the user by way of their fingerprint (a unique,
unrepeatable characteristic). With built-in proximity reader
which functions as follows:
- Some people have fingerprints without the necessary
information for authorization in a biometric system. This applies
to 1% of the population. In these cases, use integrated
Proximity.
- Security mode: activates dual security, (Fingerprint+Card) for
the same User.
• Integrated within the Cityline aluminum panel.
• Flush mounted (ref.8948, including box) or surface
installation (ref.7061, optional).
• Recommended for interior and exterior use.
• Reader and controller integrated within the same module.
• Can run as an stand-alone or centralised system
(dipswitch configurable).
Configuration as a STAND-ALONE system:
• Capacity (no. users):
- 4.500 users in 1 fingerprint per person mode.
- 2.970 users in 2 fingerprints per person mode.
• Acoustic and visual confirmation using status and display
LEDs which indicate if a fingerprint has been accepted or
rejected.
• To ensure the ngerprint is read correctly, slide your nger along
the reader with a downwards movement (from top to bottom),
at a uniform speed and exerting slight pressure.
• Includes a software CD and infrared remote keypad.
PROGRAMMING
TECHNICAL FEATURES
• Relay lock-release activation. Programmable from
01 to 99 seconds.
• Acoustic and visual status data.
• Reader with 2 status LEDs and a 7 segment 4 digit
display (helps with programming and status data).
• Manual programming using the infrared remote
control included or via PC software (card activation/
deactivation of fingerprints).
• Special Functions: free ngerprint button (trades) and
unblock fingerprint (lock-release always activated).
• Door sensor and exit button control.
• Auxiliary Relay for other Functions. Door alarm and
forced door, panic alarm or intruder alarm (incorrect
fingerprint).
• Allows keypad connection for Security Mode
operation: in this case, the dual security would be
Fingerprint+Code, for the same User.
Programming can be done manually or by PC. The system
is programmed with a master print (Administrator) and a
remote infrared keypad. The PC programming software can be
downloaded from www.fermax.com. The «Clone» option is available:
it is used to copy all data entered in one reader into another.
NOTE: See
“Installation
diagrams for
stand-alone
in network
fingerprint
readers”.
Built-in Proximity reader
The fingerprint reader is located in the exterior area. The
rest of the devices are connected to this module and they
are installed in the building's interior: power supply and
lock-release. An exit button can be used optionally.
INSTALLATION
Dimensions: (horizontal)x(vertical)x(depth) mm
SPECIFICATIONS
• Dimensions:
* Reader
* Flush Mounted Box
* Surface Box
• Environmental Protection (IP)
• Anti-Shock Protection (IK)
• Power Supply (V)
• Consumption (mA) S/lock-release
• Operating Temperature
130x128
115x114x45
130x128x33
43
07
12V (ac/dc)
118/173
-10º to 55ºC
Lock-Releases
Exit Button
Power Supply
Ref.6959
230Vac
2
2
2
2
024
STAND-ALONE
* Door lock recommended.
12Vdc
12Vac
30708
3071
2888
2880
Normal
References
Reinforced
To Next Page
Loading...
