CENTRALISED
Wiegand26-Data/Clock
Cityline Fingerprint
Fingerprint
• Biometric access ngerprint reader with capacitive sensor.
Identifies the user by way of their fingerprint (unique, unrepeatable
characteristic for each individual). With built-in proximity reader
which works as follows:
- Some people have fingerprints which do not have the necessary
information to authorize them in a biometric system. This applies to
some 1% of the population. In these cases, use integrated Proximity.
- Security mode: activates dual security, (Fingerprint+Card) for the
same User.
• Integrated in Cityline aluminum panel.
• Flush mounted (ref.8948, including box) or surface installation
(ref.7061, optional).
• Recommended for interior and exterior use.
• Requires a door controller (ref.4420) for its connection and
operation.
• Can function as stand-alone or centralized system (dipswitch
configurable).
Configuration as a CENTRALISED system with
Wiegand26-Data/Clock protocol:
• Capacity (number of users):
- 1.020 users with MDS Central Unit (ref.2405).
- 2.048 users with CAC Central Unit (ref.4410).
Note: prints are authorized in the reader and then sent on
to the Central Unit.
• Acoustic and visual confirmation using status LEDs
which indicate if a fingerprint has been accepted or rejected.
• Reading Method. You must swipe your ngerprint across
the reader in a downwards movement (from top to bottom)
at a uniform speed and exerting slight pressure.
• Includes a software CD and infrared remote keypad.
Programming is done thanks to the software package which can
be downloaded from www.fermax.com. The fingerprint codes are
provided by the PC application and should be set up on the control
system (central unit).
PROGRAMMING
Dimensions: (horizontal)x(vertical)x(depth) mm
SPECIFICATIONS
• Dimensions:
* Reader
* Flush Mounted Box (included)
* Surface Box (optional)
• Environmental Protection (IP)
• Anti-Shock Protection (IK)
• Power Supply (V)
• Consumption (mA) S/lock-release
• Operating Temperature
130x128
115x114x45
115x128x33
43
07
12Vdc
118
-10º to 55ºC
• The Wiegand Readers (WG) allow greater anti-
vandalism security given that the reader is not
connected to the lock-release mechanism or
the exit button. All devices are connected to
the door controller and therefore are outside
the range for interference. The door controller is
installed in the interior area (secure area) and the
reader in the exterior.
• The reader can be used with other door
controllers which use Wiegand 26 (WG) or Data/
Clock protocols.
• Wiring: 7 wires to the door controller.
• For more information see the door controller's
Technical Features section.
INSTALLATION (BASIC)
See “Centralized
Fingerprint Reader
Installation Diagram".
TECHNICAL FEATURES
Wiegand26-Data/Clock
Loft Proximity+Keypad
Ref.6959
Reader
module
7
2
024
ReaderReader
Up to 32 readers
C.U. (ref.2405 or ref.4410)
Twisted Pair
PC Connection Access (necessary) ref.24661
Twisted Pair Twisted Pair
2
2
7 7
2
Power Supply
Pc
024 024
Door lock recommended:
12Vdc 30708 2888 29580
Normal
Normal
w/sensor
References
Reinforced
Built-in Proximity reader
To Next Page
Loading...
