A Diagnostic messages
216 Festo – GDCP-CMMS/D-FW-EN – 1404NH – English
A Diagnostic messages
A.1 Explanations on the diagnosti c messages
The f ollowing table summarises the significance of the diagnostic me ssages and the actions to be
takeninresponsetothem:
Terms
Meaning
No. Main index ( error group) and sub-index of the diagnostic message.
Indication via the 7-segment display, in FCT or in the diagnostic memory via
FHPP.
Code The Code column includes the error c ode (Hex) via CiA 301.
Message Message that is displayed in the FCT.
Cause Possible causes for the message.
Action Action by the user.
Reaction The React ion column includes the error response (default setting, partially
configurable):
– PS off (block output stage),
– QStop (fast stop with parameterised ramp),
–Warn(warning),
–Ignore.
Tab. A.1 Explanations on the diagnostic messages
For a complete list of the diagnostic messages that correspond to the firmware versions used at the
time of printing this document, please refer to section A.2.
Under section A.3, you will find the error codes in ac c ordance with CiA301/402 and the error bit num-
bers with assignment to the error numbers of the diagnostic messages.
Under section A.4, you will find the PROFIBUS diagnostic bits with assignment to the error numbers of
the diagnostic messages.