Festo CMMS-AS-C4-3A-G2 Description

5 Commissioning
92 Festo – GDCP-CMMS/D-FW-EN – 1404NH – English
5.2.7 Parameter file (.DCO)
The parameter file (.DCO) c ontains the complete parameter set for the motor controller.
The parameter file (.DCO) c an be transferred between the memory card and motor controller as follows:
– SD>>Controller/after restart ... ( read): From the memory card to the motor controller
– Controller>>SD ( write): From the motor controller to the memory card
Requirement for parameter file names
File names
Example
Letters Format File name Exte nsion
large 8.3 8-digit
1)
.DCO CMMS-AS: CMMSAS01.DCO
CMMS-ST: CMMSST01.DCO
CMMD-AS: CMMDAS01.DCO
1) xxxxxxnn.DCO:
x = digits 1–6 are used for the file name. Any ASCII characters can be used here.
n = digits 7+8 are used for the consecutive number of the file. This increases automatically from “00”.
Tab. 5.8 Requirement for parameter file names

Festo CMMS-AS-C4-3A-G2 Specifications

General

Brand	Festo
Model	CMMS-AS-C4-3A-G2
Category	Controller
Language	English