Maintenance Instructions
Seite/Page 138 - Kaptitel/Chapter 7: Maintenance Instructions 18.12.15
Fig. 7.12.2-19: Cleaning the shaftClean the shaft
Fig. 7.12.2-20: Checking the wheel treadCheck the wheel tread for damages
The wheel tread has to be
- clean
- free of partial damages (drafts, indentations, notches,
scratches).
Fig. 7.12.2-21: Mounting the bearing housingMounting the bearing housing inside the generator cap:
Put the bearing housing loosely into the generator cap;
securing it against dropping out with one hand.
Please make sure the housing is mounted in the same
position as it was before - the marking that have been made
before dismounting have to fit to each other again!
To Next Page
Loading...
