Flexicon PF7 - Pump Info; Sound Level

The date is preset in the factory and is not adjustable.
25.17 Pump info
View various information specific to the pump.
Table 24 - Read only information displayed in pump info
Software version
HMI Application
Main Application
IO Application
Bootloader version
HMI Application
Main Application
IO Application
21 CFR part 11 compliance On/Off
Run hours Total pump run hours
Website WMFTG website
Model PF7/PF7+
Mac address -
i
The option to enable or disable FDA 21CFR Part 11
compliance is only available during initial setup. To change
FDA 21CFR Part 11 compliance between enabled or
disabled, factory reset the pump. (Refer to "Backup and
reset" on the next page).
After USB firmware update:
• Software version will change. Use this software version to find the
compatible version of NetTools.
• Bootloader version is factory set and will not change.
Refer to "Backup and reset" on the next page.
25.18 Sound level
Sets sound volumes for:
• keypad beep
• recalibration
• start fill
• end fill tones
PF7/PF7+ Peristaltic Filler with QC14 Pumphead User Manual 115
EN EN EN EN EN EN EN EN EN EN EN EN EN EN EN EN EN