176 PF7/PF7+ Peristaltic Filler with QC14 Pumphead User Manual
38 List of figures
Figure 1 - Lifting point locations 17
Figure 2 - Key features of QC14 pumphead 18
Figure 3 - Pumphead mounting and removal 19
Figure 4 - Filling time 22
Figure 5 - Y-connector selection 22
Figure 6 - Fluid path layout 23
Figure 7 - Opening the pumphead 25
Figure 8 - Removing the tube from the pumphead 26
Figure 9 - Loading the tube into the pumphead 27
Figure 10 - Closing the pumphead 28
Figure 11 - Voltage selector. 29
Figure 12 - Power supply socket 30
Figure 13 - How to remove the fuse holder 31
Figure 14 - Fuse position 31
Figure 15 - The rear of the pump. Image shows PF7+. PF7 rear panel looks
slightly different. M12 connectors are located in the same place. 32
Figure 16 - Keypad 39
Figure 17 - USB keyboard mapping 40
Figure 18 - Successful connection of a Mettler-Toledo ML-T balance indicated
by a white icon on the Screen info bar. Successful connection of another
compatible balance indicated by a grey icon on the Screen info bar. 41
Figure 19 - Menu navigation 56
Figure 20 - Recipe screen 57
Figure 21 - Acceptable fill—Green 63
Figure 22 - Unacceptable fill—Red 63
Figure 23 - Calibration icon 70
Figure 24 - Feature availability by pump and balance configuration 81
Figure 25 - Batch dispense screen 82
Figure 26 - Dispensing or ready to dispense screen 83
Figure 27 - Successful connection of a Mettler-Toledo ML-T balance indicated
by a white icon on the Screen info bar. Successful connection of another
compatible balance indicated by a grey icon on the Screen info bar. 86
Figure 28 - Setup with PF7+, Asepticsu and the Flexicon Advanced Filling Kit 93
Figure 29 - Example PF7+ batch report (Printed from NetTools not a USB
thermal printer.) 102
Figure 30 - Top level folder of USB flash drive 118
To Next Page
Loading...
