Flexicon PF7 - Page 4

20.17.1 Setting fill tolerance limits 64
20.18 Auto-recalibration tolerance 65
20.19 Recalibration reminder 65
20.20 Recalibration pause 65
20.21 Protected recipe 66
20.22 Save recipe 66
20.23 Print recipe 66
20.24 Delete recipe 66
21 Priming and continuous pumping mode 67
21.1 Prime slow and Prime fast 68
21.2 Continuous pumping 68
21.3 Fluid recovery 69
21.4 Priming the pump 69
21.4.1 Eliminating trapped air from the tube 69
22 Calibrate mode 70
22.1 Single-fill calibration with a balance connected 71
22.1.1 Calibration value entry 71
22.1.2 Calibration summary 72
22.2 Single-fill calibration without a balance connected 73
22.2.1 Calibration summary 74
22.3 Multi-fill calibration with a balance connected 75
22.3.1 Calibration summary 77
22.4 Multi-fill calibration without a balance connected 78
22.4.1 Calibration summary 80
23 Dispense mode 81
23.1 Batch size 81
23.2 Batch name 81
23.3 Start manual batch 82
23.3.1 Calibration whilst dispensing 83
23.3.2 Auto-recalibration 85
23.3.3 Pausing a batch 87
23.3.4 Calibration whilst paused 88
23.3.5 Add note to report 89
23.3.6 Fluid sample 90
PF7/PF7+ Peristaltic Filler with QC14 Pumphead User Manual 4
EN EN EN EN EN EN EN EN EN EN EN EN EN EN EN EN EN