7 - 3
OMNISCANNER User Guide
To view detailed information about a saved Autotest use the éê on
your keypad to highlight a Circuit ID in the Project Name screen and
press ENTER.
For Twisted Pair Cabling:
The Autotest Results screen will be displayed. The name of the Au-
totest, the cable that was used to run the test, and
the overall test result (PASS or FAIL) are shown.
All measurements that were performed during the
Autotest are listed in the left column. Passed tests
are marked with a (PASS) or a (Marginal
PASS). If a test result did not pass, the test name
will be followed by a (Fail) or a (Marginal
FAIL) symbol.
Note
The list of tests varies depending on the kind of Autotest that was
performed. (See Chapter 5 - Measurements for detailed information
about each measurement screen.)
Use the éê on your keypad to highlight a test.
Press ENTER to open the test result screen for that particular test.
Use the ç or è on your keypad to quickly page through all test
results.
Note
If (Save with Graphs) or (Save with Graphs to MMC)
was selected when saving the Autotest, graphs associated with NEXT,
Attenuation, Return Loss, PSNEXT, ELFEXT, ACR, PSELFEXT, and/or
PSACR are available when viewing Autotest results. Only the graphs
that were selected in the SAVE OPTIONS screen will be saved. (See
Chapter 4 - Setup: Save Options for information about selecting
graphs to be saved.)
Press ESC to return to the PROJECT NAME screen.
Press ESC to return to the RESULTS screen.
To Next Page
Loading...
