Fluke OMNIScanner 2 - Page 101

OMNISCANNER User Guide
7 - 4
For Fiber Optic Cabling:
The Autotest Results screen will be displayed. The name of the Au-
totest, the cable that was used to run the test, and the overall test
result ( PASS or FAIL) for both fibers are shown.
, , , or (Loopback) are displayed to indicate the Method used
to set the reference. (See Chapter 8 - Fiber Optic Reference for further
information.)
When dual fiber is measured, arrows st at the top
of the screen point out the direction of the light.
The arrows also indicate the fiber that the
(PASS) or (FAIL) result is for.
The number of Connectors and Splices is shown at
the bottom of the screen if the Autotest loss
criteria is formula based. (See Appendix C for
further information.)
Press or to toggle between the results for OMNISCANNER
and OMNIREMOTE.
Press ESC to return to the PROJECT NAME screen.
Press ESC to return to the RESULTS screen.
For Coaxial Cabling:
The COAX TESTS result screen displays the results
for length, termination, impedance, and resis-
tance.
(See Chapter 5 -Measurements: Coax Tests for
further information.)
Press ESC to return to the PROJECT NAME
screen.
Press ESC to return to the RESULTS screen.