Start machine corrections. As soon as machine movement is detected, the "Undo" icon
is replaced by the "Cancel" icon .
CAUTION
Do NOT attempt to move the machine using heavy sledgehammer blows. This can cause
bearing damage, and also produce inaccurate Live Move results. Jack bolts on the feet
or other mechanical or hydraulic devices are recommended for moving machines.
Move the machines until the alignment condition is within the specified tolerance which is indic-
ated by the smiley (1) then tap to finish Live Move.
Access the "Train manager" by tapping the mini train inset, to view the alignment condition of
the entire machine train.
128 Version:2.3
On-board help
To Next Page
Loading...