If the sensor firmware update is not carried out when the notification appears, the update
action may be initiated via "Sensor properties". An "UPDATE" hint appears next to the older
sensor firmware version.
Tap "UPDATE" to proceed with the sensor firmware update.
Note
The sensor firmware update notification continues to appear once per day until the firm-
ware update is completed.
Notification on sensor and laser calibration
Note
The calibration accuracy of both the sensor and the laser should be checked every two
years as indicated on the round label affixed to the back of the respective component.
Both sensor and laser should be returned to an authorized PRÜFTECHNIKservice center
for calibration checking and inspection. You may contact your local
PRÜFTECHNIKrepresentative for assistance or visit www.pruftechnik.com.
Note
The sensor calibration due date is also found under "Sensor properties".
154 Version:2.3
On-board help
To Next Page
Loading...