To Next Page

To Previous Page

System virtual domain Virtual domains

FortiGate-3000 Administration Guide 01-28006-0010-20041105 143

See the following procedures for configuring virtual domains:

• To add VLAN subinterfaces to a virtual domain

• To view the interfaces in a virtual domain

• To add zones to a virtual domain

• To select a management virtual domain and add a management IP

• To configure routing for a virtual domain in NAT/Route mode

• To configure the routing table for a virtual domain in Transparent mode

• To add firewall policies to a virtual domain

• To add firewall addresses to a virtual domain

• To add IP pools to a virtual domain

• To add Virtual IPs to a virtual domain

• To configure VPN for a virtual domain

Adding a virtual domain

To add a virtual domain

1 Go to System > Virtual domain.

2 Select Create New.

3 Enter a virtual domain Name.

The virtual domain must not have the same name as a VLAN or zone.

4 Select OK.

Selecting a virtual domain

The following procedure applies to NAT/Route and Transparent mode.

To select a virtual domain to configure

1 Go to System > Virtual domain > Virtual domains.

2 Select Change following the current virtual domain name above the table.

3 Choose the virtual domain to configure.

4 Select OK.

The footer of the web-based manager page displays the selected virtual domain name

if the information and configuration options on the page are exclusive to the virtual

domain. Otherwise, the footer displays “Virtual Domain: all”. See “Exclusive virtual

domain properties” on page 140.

Selecting a management virtual domain

In NAT/Router mode, you select a virtual domain to be used for system management.

In Transparent mode, you must also define a management IP. The interface that you

want to use for management access must have Administrative Access enabled. See

“To control administrative access to an interface” on page 62.

Fortinet FortiGate FortiGate-3000 Administration Guide

Other manuals for Fortinet FortiGate FortiGate-3000