Router CLI configuration
FortiGate-3000 Administration Guide 01-28006-0010-20041105 171
3 Specify the network for which to display routes.
4 Specify a gateway to display the routes using that gateway.
5 Select Apply Filter.
CLI configuration
This guide only covers Command Line Interface (CLI) commands, keywords, or
variables (in bold) that are not represented in the web-based manager. For complete
descriptions and examples of how to use CLI commands see the FortiGate CLI
Reference Guide.
get router info ospf
Use this command to display information about OSPF.
Command syntax
get router info ospf {border-routers | database | interface |
neighbor | route | virtual-links}
Examples
get router info ospf database
get router info ospf interface
get router info protocols
Show the current state of active routing protocols.
Command syntax
get router info protocols
Note: You can configure Type, Network, and Gateway filters individually or in any combination.
router info ospf command keywords and variables
Keywords and variables Description Availability
border-routers Show OSPF routing table entries that have an Area
Border Router (ABR) or Autonomous System
Boundary Router (ASBR) as a destination.
All models.
database Show the entries in the OSPF routing database. All models.
interface Show the status of the FortiGate interfaces and
whether OSPF is enabled for each interface.
All models.
neighbor Show information about OSPF neighbors. All models.
route Show the OSPF routing table. All models.
virtual-links Show information about OSPF virtual links. All models.
To Next Page
Loading...
Need help?
General