Fortinet FortiGate FortiGate-3000 Administration Guide

160 01-28006-0010-20041105 Fortinet Inc.
RIP Router
Distribute list options
Figure 63: RIP Distribute list configuration
To configure a distribute list
1 Go to Router > RIP > Distribute List.
2 Select Create New to add a new distribute list or select the edit icon beside an existing
distribute list to edit that distribute list.
3 Set Direction to In or Out.
4 Select either prefix-list or access-list.
5 Select the prefix list or access list to use for this distribute list.
6 Select an interface to apply this distribute list to, or select the blank entry to apply this
distribute list to all interfaces.
7 Select or clear the Enable check box to enable or disable this distribute list.
8 Select OK.
Create New Add a new distribute list.
Direction The direction for the filter.
Filter The type of filter and the filter name.
Interface The interface to use this filter on. If no interface name is displayed, this
distribute list is used for all interfaces.
Enable The status of this distribute list.
The Delete and Edit icons.
Direction Set the direction for the filter. Select In to filter incoming packets. Select
Out to filter outgoing packets.
prefix-list Select prefix-list to use a prefix list for this distribute list. Select the name
of the prefix list to use for this distribute list.
access-list Select access-list to use an access list for this distribute list. Select the
name of the access list to use for this distribute list.
Interface Select the name of the interface to apply this distribute list to. If you do
not specify an interface, this distribute list will be used for all interfaces.
Enable Select Enable to enable the distribute list.

Fortinet FortiGate FortiGate-3000 Specifications

General

Brand	Fortinet
Model	FortiGate FortiGate-3000
Category	Firewall
Language	English