To Next Page

To Previous Page

Router Policy

FortiGate-3000 Administration Guide 01-28006-0010-20041105 153

Figure 54: Move a static route

3 For Move to, select either Before or After and type the number that you want to place

this route before or after.

4 Select OK.

The route is displayed in the new location on the static route list.

Policy

Using policy routing you can configure the FortiGate unit to route packets based on:

• Source address

• Protocol, service type, or port range

• Incoming or source interface

The FortiGate unit starts at the top of the policy routing list and attempts to match the

packet with a policy. The policy route supplies the next hop gateway as well as the

FortiGate interface to be used by the traffic. If no policy route matches the packet, the

FortiGate unit routes the packet using the regular routing table.

Policy route list

Figure 55: Policy routes

Create New Add a new policy route.

# The sequence number for this policy route.

Incoming The policy route attempts to match packets received on this interface.

Outgoing The policy route sends packets out this interface.

Source The policy route matches packets that have this source IP address and netmask.

Destination The policy route matches packets that have this destination IP address and

netmask.

The Delete, and Edit icons.

Fortinet FortiGate FortiGate-3000 Administration Guide

Other manuals for Fortinet FortiGate FortiGate-3000