156 01-28006-0010-20041105 Fortinet Inc.
RIP Router
To configure RIP general settings
1 Go to Router > RIP > General.
2 Select the default RIP Version.
3 Change the Default Metric if required.
4 Select Enable Default-information-originate if the configuration requires advertising a
default static route into RIP.
5 Only change the RIP timers if required.
RIP timer defaults are effective in most configurations. All routers and access servers
in the network should have the same RIP timer settings.
6 Select Apply.
To configure RIP route redistribution
1 Go to Router > RIP > General.
2 Select Connected or Static or both.
3 Enter the Default Metric to be used for the redistributed routes.
4 Select a Route-map name.
5 Select Apply.
Networks list
Identify the networks for which to send and receive RIP updates. If a network is not
specified, interfaces in that network will not be advertised in RIP updates.
Figure 58: RIP Networks list
Route-map Enter the name of the route map to use for the redistributed connected
routes. For information on how to configure route maps, see “Route-map
list” on page 165.
Static Advertise routes learned from static routes.
Metric Enter the metric to be used for the redistributed static routes.
Route-map Enter the name of the route map to use for the redistributed static routes.
For information on how to configure route maps, “Route-map list” on
page 165.
Create New Add a new RIP network.
IP/Netmask The IP address and netmask for the RIP network.
The Delete, and Edit icons.
To Next Page
Loading...
