EasyManuals Logo

Fortinet FortiGate FortiGate-3000 Administration Guide

Fortinet FortiGate FortiGate-3000
398 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
90 01-28006-0010-20041105 Fortinet Inc.
HA System config
To select a language for the web-based manager
1 Go to System > Config > Options.
2 From the Languages list, select a language for the web-based manager to use.
3 Select Apply.
To set PIN protection for the LCD panel
1 Go to System > Config > Options.
2 In the LCD Panel section, select the PIN Protection check box.
3 Type a 6-digit PIN.
4 Select Apply.
To modify the dead gateway detection settings
Modify dead gateway detection to control how the FortiGate unit confirms connectivity
with a ping server added to an interface configuration. For information about adding a
ping server to an interface, see “To add a ping server to an interface” on page 62.
1 Go to System > Config > Options.
2 For Detection Interval, type a number in seconds to specify how often the FortiGate
unit tests the connection to the ping target.
3 For Fail-over Detection, type a number of times that the connection test fails before
the FortiGate unit assumes that the gateway is no longer functioning.
4 Select Apply.
HA
Fortinet achieves high availability (HA) using redundant hardware and the FortiGate
Clustering Protocol (FGCP). Each FortiGate unit in an HA cluster enforces the same
overall security policy and shares the same configuration settings. You can add up to
32 FortiGate units to an HA cluster. Each FortiGate unit in an HA cluster must be the
same model and must be running the same FortiOS firmware image.
The FortiGate units in the cluster use cluster ethernet interfaces to communicate
cluster session information, synchronize the cluster configuration, synchronize the
cluster routing table, and report individual cluster member status. The units in the
cluster are constantly communicating HA status information to make sure that the
cluster is operating properly. This communication is called the HA heartbeat.
FortiGate HA supports link failover, device failover, and HA heartbeat failover.
Note: You should select the language that the management computer operating system uses.

Table of Contents

Other manuals for Fortinet FortiGate FortiGate-3000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fortinet FortiGate FortiGate-3000 and is the answer not in the manual?

Fortinet FortiGate FortiGate-3000 Specifications

General IconGeneral
BrandFortinet
ModelFortiGate FortiGate-3000
CategoryFirewall
LanguageEnglish

Related product manuals