EasyManuals Logo

Fortinet FortiGate FortiGate-3000 Administration Guide

Fortinet FortiGate FortiGate-3000
398 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #191 background imageLoading...
Page #191 background image
Router CLI configuration
FortiGate-3000 Administration Guide 01-28006-0010-20041105 191
network-type
{broadcast | non-
broadcast
| point-to-
multipoint
| point-to-point}
Specify the type of network to
which the interface is
connected.
OSPF supports four different
types of network. This
command specifies the
behavior of the OSPF interface
according to the network type.
If you specify the non-
broadcast keyword, you
must also configure neighbors
using “config neighbor” on
page 185.
broadcast
All models.
priority
<priority_integer>
Set the router priority for this
interface.
Router priority is used during
the election of a designated
router (DR) and backup
designated router (BDR).
An interface with router priority
set to 0 can not be elected DR
or BDR. The interface with the
highest router priority wins the
election. If there is a tie for
router priority, router ID is
used.
Point-to-point networks do not
elect a DR or BDR; therefore,
this setting has no effect on a
point-to-point network.
The valid range for
priority_integer is 0 to
255.
1 All models.
retransmit-interval
<seconds_integer>
The time, in seconds, to wait
before sending a LSA
retransmission. The value for
the retransmit interval must be
greater than the expected
round-trip delay for a packet.
The valid range for
seconds_integer is 1 to
65535.
5 All models.
status
{disable | enable}
Enable or disable OSPF on
this interface.
enable All models.
transmit-delay
<seconds_integer>
The estimated time, in
seconds, required to send a
link state update packet on this
interface.
OSPF increments the age of
the LSAs in the update packet
to account for transmission
and propagation delays on the
interface.
Increase the value for
transmit-delay on low
speed links.
The valid range for
seconds_integer is 1 to
65535.
1 All models.
ospf-interface command keywords and variables (Continued)
Keywords and variables Description Default Availability

Table of Contents

Other manuals for Fortinet FortiGate FortiGate-3000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fortinet FortiGate FortiGate-3000 and is the answer not in the manual?

Fortinet FortiGate FortiGate-3000 Specifications

General IconGeneral
BrandFortinet
ModelFortiGate FortiGate-3000
CategoryFirewall
LanguageEnglish

Related product manuals