3.4 Programming Mode
3-24
Basic key operation
The basic key operation is just like that in Menu #0 "Quick Setup."
(1) Turn the inverter ON. It automatically enters Running mode. In that mode, press the
key to
switch to Programming mode. The function selection menu appears.
(2) Use the
and keys to display the desired function code group from the choices
!f__
through
!y__
.
(3) Press the
key to proceed to the list of function codes for the selected function code group.
(4) Use the
and keys to select the desired function code, then press the key.
The data of this function code appears.
(5) Change the function code data using the
and keys.
(6) Press the
key to establish the function code data.
The
saue
appears and the data will be saved in the memory inside the inverter. The display will
return to the function code list, then move to the next function code.
Pressing the
key instead of the key cancels the change made to the data and displays the
original function code.
(7) Press the key
to return to the menu from the function code list.
To Next Page
Loading...
