Fuji Electric Frenic Mega Series - Running in Various Operation Modes

5.3 Code Index by Purpose
5-47
Chapter 5 Function Code
5.3.12 Running in various operation modes
Table 5.3-16
To
Function
code
Name
Refer to
page:
Jog (inch) the motor with the keys on the
keypad.
Jog (inch) the motor with signals sent to
terminals [FWD] or [REV].
Jogging
Operation
Enable JOG from communication.
C20
H54
H55
E01 to E09
d99
*4
Jogging Frequency
Acceleration Time (Jogging)
Deceleration Time (Jogging)
Terminal [X1] to [X9] Functions
(JOG)
Extended Function 1
5-168
5-76
5-122
5-248
Enable auto energy saving operation.
F37
H67
Load Selection/Auto Torque
Boost/Auto Energy Saving
Operation 1
Auto Energy Saving Operation
(Mode selection)
5-104
Auto energy
saving operation
Manage energy.
E51
E01 to E09
Display Coefficient for Input
Watt-hour Data
Terminal [X1] to [X9] Functions
(SW50, SW60)
5-160
5-122
Operation by
commercial
power supply
Switch to commercial-power operation for
energy saving or backup power supply to be
used when an alarm occurs in the inverter.
J22
H13
E01 to E09
E20 to E24
Commercial Power Switching
Sequence
Restart Mode after Momentary
Power
Failure (Restart time)
Terminal [X1] to [X9]
(ISW50, ISW60)
Terminal [Y1] to [Y5A/C]
(SW88, SW52-1, SW52-2)
5-135
5-83
5-122
5-141
Switching
between motors
Drive two or more motors with a single inverter
by switching between those motors.
A42
b42
r42
E01 to E09
E20 to E24
Motor/Parameter Switching 2 to 4
(Mode selection)
Terminal [X1] to [X9] Functions
(M2, M3, M4)
Terminal [Y1] to [Y5A/C]
Functions (SWM1, 2, 3, 4)
5-211
5-122
5-141
*4 Available for inverters with ROM version 3600 or later.