Fuji Electric Frenic Mega Series - Page 229

5.3 Code Index by Purpose
5-48
Table 5.3-17
To
Function
code
Name
Refer to
page:
Brake signal
Use brake signals available for vertical carrier
machines.
J68
J69
J70
J71
J72
J95
J96
E20 to E24
Brake Signal
(Brake-OFF current)
(Brake-OFF frequency/speed)
(Brake-OFF timer)
(Brake-ON frequency/speed)
(Brake-ON timer)
(Brake-OFF torque)
(Speed selection)
Terminal [Y1] to [Y5A/C]
Functions (BRKS)
5-229
5-141
Switching
between control
parameters
Run the motor with control parameters suited
for variable conditions (e.g., inertia) of the
machinery equipped with gear change.
A42
b42
r42
E01 to E09
E20 to E24
d25
Motor/Parameter Switching 2 to 4
(Mode selection)
Terminal [X1] to [X9] Functions
(M2, M3, M4)
Terminal [Y1] to [Y5A/C]
Functions (SWM1, 2, 3, 4)
ASR Switching Time
5-211
5-122
5-141
E01 to E09
E20 to E24
Terminal [X1] to [X9] Functions
(Hz2/Hz1)
Terminal [Y1] to [Y5A/C]
Functions (SY)
5-122
5-141
d14
d15
d16
d17
Feedback Input
(Pulse input format)
(Encoder pulse resolution)
(Encoder pulse resolution)
(Encoder pulse resolution)
5-239
d41 Application-defined control 5-245
d59
d60
d61
d62
d63
Command (Pulse Rate Input)
(Pulse input format)
(Encoder pulse resolution)
(Filter time constant)
(Pulse count factor 1)
(Pulse count factor 2)
5-62
SY Synchronous
Operation
Perform synchronous operation using PG
interface card (OPC-G1-PG/
OPC-G1-PG22).
*3
d71
d72
d73
d74
d75
d76
d77
d78
Synchronous operation
(Main ASR gain)
(APR P gain)
(APR output + side limitter)
(APR output - side limitter)
(Z phase agreement gain)
(Synchronous offset angle)
(Synchronization completion
detection angle)
(Deviation excess detection
width)
5-247
Battery-driven
operation
*4
Run the inverter in an undervoltage status with
a battery power supply.
E01 to E09
U81 to U85
Terminal [X1] to [X9] Functions
(BATRY)
Customizable Logic Output
Signals 1 to 5
(Function selection)
5-122
5-249
Pattern operation
*5
Perform pattern operation with predetermined
run time, rotation direction, ACC/DEC time, and
reference frequency.
F01/C30
C21
C22 to C28
C82 to C88
Select frequency command 1/2
Pattern operation
(Mode selection)
(Stage 1 to 7 run time)
(Stage 1 to 7 rotation direction;
ACC/DEC time)
*4 Available for inverters with ROM version 3600 or later.
*5 Available for inverters with ROM version 3800 or later.