Fuji Electric Frenic Mega Series - Test Run; Test Run Procedure

4.1 Test Run
4-1
Chapter 4 OPERATION
4.1 Test Run
4.1.1 Test run procedure
Make a test run of the motor using the flowchart given below.
This chapter describes the test run procedure with motor 1 dedicated function codes that are marked with
an asterisk (*). For motors 2 to 4, replace those asterisked function codes with motor 2 to 4 dedicated ones.
 For the function codes dedicated to motors 2 to 4, see Chapter 5 "FUNCTION CODES."
Figure 4.1-1 Test Run Procedure