Fuji Electric Frenic Mega Series - Page 13

CONTENTS
x
3.3.5 Jogging operation.................................................................................3-14
3.3.6 Remote and local modes......................................................................3-15
3.3.7 External run/frequency command ........................................................3-16
3.4 Programming Mode........................................................................................3-17
3.4.1 Setting up basic function codes quickly "Quick Setup"........................3-19
3.4.2 Setting up function codes Menu #1 "Data Setting" .............................. 3-22
3.4.3 Checking changed function codes Menu #2 "Data Checking"............. 3-25
3.4.4 Monitoring the running status Menu #3 "Drive Monitoring"..................3-26
3.4.5 Checking I/O signal status Menu #4 "I/O Checking"............................ 3-30
3.4.6 Reading maintenance information Menu #5
"Maintenance Information" ...................................................................3-35
3.4.7 Reading alarm information Menu #6 "Alarm Information"....................3-40
3.4.8 Copying data Menu #7 "Data Copying"................................................ 3-43
3.5 Alarm Mode ....................................................................................................3-47
3.5.1 Releasing the alarm and switching to Running mode..........................3-47
3.5.2 Displaying the alarm history.................................................................3-47
3.5.3 Displaying the status of inverter at the time of alarm........................... 3-47
3.5.4 Switching to Programming mode .........................................................3-47
3.6 USB Connectivity............................................................................................ 3-49
Chapter 4 OPERATION
4.1
Test Run............................................................................................................4-1
4.1.1 Test run procedure .................................................................................4-1
4.1.2 Checking prior to powering on ...............................................................4-2
4.1.3 Powering on and checking..................................................................... 4-2
4.1.4 Selecting an inverter drive mode (HD/MD/LD).......................................4-3
4.1.5 Selecting a motor drive control...............................................................4-4
4.1.6 Basic settings of function codes < 1 >....................................................4-8
4.1.7 Basic settings/tuning of function codes < 2 >.........................................4-9
4.1.8 Basic settings/tuning of function codes < 3 >.......................................4-12
4.1.9 Basic settings of function codes < 4 >..................................................4-17
4.1.10 Basic settings of function codes < 5 >..................................................4-18
4.1.11 Basic settings/tuning of function codes < 6 >.......................................4-19
4.1.12 Running the inverter for motor operation check...................................4-22
4.1.13 Preparation for production run .............................................................4-24
4.2 Special Operation ........................................................................................... 4-25
4.2.1 Jogging operation.................................................................................4-25
4.2.2 Remote and local modes......................................................................4-26
4.2.3 External run/frequency command ........................................................4-27
Chapter 5 FUNCTION CODES
5.1
Overview of Function Codes ............................................................................ 5-1
5.2 Function Code Tables.......................................................................................5-2
5.3 Code Index by Purpose.................................................................................. 5-37
5.3.1 Configuring the minimal requirements for the inverter to just run
the motor ..............................................................................................5-37
5.3.2 Setting up the frequency ...................................................................... 5-37
[1] Frequency setting from the keypad.....................................................5-37
[2] Frequency setting by analog input ...................................................... 5-37
[3] Other frequency settings .....................................................................5-38
5.3.3 Entering a run command......................................................................5-39
5.3.4 Starting/stopping the motor ..................................................................5-40
5.3.5 Specifying the acceleration/deceleration (time, mode, and pattern)....5-40