11.4 Option
11-94
Communications formats
G11 standard format data allocation address
When the G11 standard format is selected (o30 = 0), an eight-word area per inverter is used in the I/O
relay area as shown below. The lower four words are status area for reading out data from the inverter to
the MICREX; the upper four words are control area for writing data from the MICREX into the inverter.
Note: Asterisks (**) denote a T-Link bus station address configured by the RSW1 and RSW2.
Figure 11.4-35
G9 compatible format data allocation address
When the G9 compatible format is selected (o30 = 2), an eight-word area per inverter is used in the I/O
relay area as shown below. The lower four words are status area for reading out data from the inverter to
the MICREX; the upper four words are control area for writing data from the MICREX into the inverter.
This format has been designed to minimize the program change in the controller when the FRENIC5000
G9 series is replaced with the FRENIC-MEGA series.
Note: Asterisks (**) denote a T-Link bus station address configured by the RSW1 and RSW2.
Figure 11.4-36
To Next Page
Loading...
