z
When you select [Full Access Password] or [Open Password] in [Digital Certificate (V4 Incompatible)], the
same certificate name may be redundantly displayed in [Security Settings] of a DocuWorks document to be
generated, in the following conditions. However, this does not affect the operation.
z
When you created a job flow on the machine, the same certificate was selected redundantly.
z
The certificate data was obtained from an LDAP server, and the same certificate was selected redundantly.
îš„ Digital Certificate (V5 or later)
Encrypts the file by the 128 bit AES method using a certificate. Files encrypted by this
method can be opened with DocuWorks Ver. 5.0 or later.
Select [Certificate] to set a certificate.
îš„ Digital Certificate (V8 or later)
Encrypts the file by the 256 bit AES method using a certificate. Files encrypted by this
method can be opened with DocuWorks Ver. 8.0 or later.
Select [Certificate] to set a certificate.
îš„ Encryption Algorithm
Displays the encryption methods.
îš„ Restricted Operations
Select file operations to assign access privileges. When assigning access privileges, set [Full
Access Password].
îš„ Open Password
Displays the [DocuWorks Security - Open Password] screen.
If you select [On] and set a password, the file is encrypted. To open the file, the password is
required. The access privileges set in [Restricted Operations] are assigned.
You can enter a password with up to 32 characters.
îš„ Full Access Password
Displays the [DocuWorks - Full Access Password] screen.
If a password is set, the password is required to change the access privileges set in
[Restricted Operations].
You can enter a password with up to 32 characters.
[DocuWorks Security - Certificate] Screen
This screen allows you to specify parties to whom the encrypted file is disclosed, and
addresses to which privileges are assigned.
To Next Page
Loading...
Need help?
General
