Properties
157
Port Settings Ethernet
Allows you to select the ethernet transmission rate.
Ethernet Settings – You can select one of the following
options.
• Auto: Detects the ethernet transmission rate
automatically.
• 10BASE-T (Half Duplex): Selects 10BASE-T (in half
duplex) as the default value.
• 10BASE-T (Full Duplex): Selects 10BASE-T (in full
duplex) as the default value.
• 100BASE-T (Half Duplex): Selects 100BASE-T (in half
duplex) as the default value.
• 100BASE-T (Full Duplex): Selects 100BASE-T (in full
duplex) as the default value.
MAC Address – Displays the MAC address of the machine.
This is a display-only item.
Parallel
Allows you to configure the parallel port settings.
Bi-directional Communication – Allows you to enable or
disable Bi-directional Communication (IEEE1284).
Auto Eject Time – Allows you to specify the time when the
paper will be automatically ejected from the printer if no data
are sent to the printer.
Adobe Communication Protocol – Only displayed when
PostScript is enabled. Select one of the following options.
• Normal: Select this when the communication protocol is in
the ASCII format.
• Binary: Select this when the communication protocol is in
the binary format.
• TBCP: Select this to switch between the specific control
codes when the communication protocols involve both
ASCII and binary formats.
USB
Allows you to configure the USB port settings.
Auto Eject Time – Allows you to specify the time when the
paper will be automatically ejected from the printer if no data
are sent to the printer.
Adobe Communication Protocol – Only displayed when
PostScript is enabled. Select one of the following options.
• Normal: Select this when the communication protocol is in
the ASCII format.
• Binary: Select this when the communication protocol is in
the binary format.
• TBCP: Select this to switch between the specific control
codes when the communication protocols involve both
ASCII and binary formats.
Feature Setting items
To Next Page
Loading...
Need help?
General
