3 Copy
68
Job Assembly
This section describes how to make settings on the [Build Job] feature. For more
information on the feature, refer to the following.
Build Job – page 68
1. Press the <All Services> button
on the control panel.
2. Select [Copy] on the touch
screen.
3. Select the [Job Assembly] tab.
Build Job
This feature allows you to make copies with different settings for individual or groups of
pages but still run the job as a single job. For example, if a job consists of some sections
with text and some with photos, you can select the appropriate settings to be applied
to each section and then print them at one time. You can also print only one set of the
job before printing out the whole quantity. This will allow you to check the print result
and adjust the settings if necessary.
1. Select [Build Job] on the [Job
Assembly] screen.
2. Select the required option.
3. Select [Save].
Off
Disables the feature.
On
Enables the feature.
Sample Set
Prints one set of the job prior to printing the whole quantity. You can choose whether
or not to print more sets after checking the print result.
• Off – Disables the feature.
• On – Enables the feature. After copying one set of the job, the job is suspended.
Select [Start] to copy the remaining sets or [Stop] to stop the job.
NOTE: Copies produced by [Sample Set] are counted towards the total copy count.
To Next Page
Loading...
Need help?
General
