11 Paper and Other Media
172
Tandem Tray Module (TTM)
The Tandem Tray Module allows you to load larger amounts of paper. It consists of two
trays.
NOTE: You cannot load custom size paper into the Tandem Tray Module.
1. Pull out Tray 3 or Tray 4 of TTM.
The elevator in the tray lowers.
2. Place the paper stock tightly
against the left rear corner of the
tray.
NOTE: Do not load paper above the
maximum fill line.
NOTE: Always load paper into the
tray in the orientation shown in the diagram.
3. Close the tray.
The elevator rises and positions the paper for use.
Auto Tray Switching
The machine automatically switches from one tray to another under the following
condition.
• When printing and the active tray runs out of paper.
• When the paper size sensed differs from the previously determined size.
• When paper feeding starts and the selected tray is open.
• When paper feeding starts and the selected tray malfunctions.
NOTE: The bypass tray cannot be used with Auto Tray Switching.
NOTE: System Administrator access is required to set target trays and priorities. For
more information, refer to Paper Tray Priority in the Setups chapter on page 183 and
Paper Type Priority in the Setups chapter on page 183.
When not in use, the paper trays can be opened and paper can be loaded while the
machine is running. However, do not open the active tray. This will cause the machine
to stop the job being processed.
To Next Page
Loading...
Need help?
General
