4 Fax/Internet Fax
72
1. Load documents face up into the
document feeder or face down
on the document glass.
For more information on how to load the documents, refer to 1. Load the Documents
on page 39.
NOTE: The long fax document scan feature has the following limitations.
• Only available when using the document feeder.
• Allows you to scan up to 600 mm in length.
• Not available when scanning both sides of document.
NOTE: For both single-sided and double-sided scanning, scanning a document at its
original size or smaller is recommended. An enlarged image may be cut off during
transmission.
2. Select the Features
The features available on the [Basic Features] screen are those used most often.
NOTE: Only those features relevant to the machine configuration will be available.
1. Press the <All Services> button
on the control panel.
2. Select [Fax/Internet Fax] on the
touch screen. Ensure that the
[Basic Features] screen is
displayed.
NOTE: If the Authentication feature
is enabled, you may be required to
enter the user ID and password (if
one is set up). If you need assistance, contact the System Administrator.
3. Press the <Clear All> button once on the control panel to cancel any previous
selections.
4. Select the button for the feature required. If [More] is selected, select [Save] to
confirm the selected feature or [Cancel] to return to the previous screen.
<Clear All> button<All Services> button
To Next Page
Loading...
Need help?
General
