12 Setups
180
Connection Interval
Select the time span for being connected to the specified server, in the range from 1 to
500 hours.
Time Server IP Address
Specify the IP address of the time server using the numeric keypad on the control
panel.
Auto Clear
With this feature enabled, the machine displays the default screen if you do not perform
any operation within the selected period of time. You can select the time period in the
range from 1 to 4 minutes. The time entry field appears only when you select [On].
Auto Job Release
With this feature enabled, if a problem such as a paper jam interrupts the current copy
or scan job and is not resolved within the selected period of time, the machine allows
execution of the next job. You can select the time period in the range from 4 to 99
minutes. The time entry field appears only when you select [On].
Auto Print
With this feature enabled, the machine allows execution of print jobs if you do not
perform any operation within the selected period of time. You can select the time period
in the range from 1 to 240 seconds. The time entry field appears only when you select
[On].
Auto Power Saver
The machine provides two types of power saver mode: Low Power and Sleep. When
in the Sleep Mode, the machine saves more power than in the Low Power Mode. The
machine enters the Low Power Mode and when you do not perform any operation
within the selected period of time, the machine automatically switches to the Sleep
Mode. You can select the time period for each mode in the range from 2 to 60 minutes.
You must select a longer time period for the Sleep Mode than for the Low Power Mode.
Audio Tones
Use this feature to select the volume level of tones to be generated at various
occasions. You can choose different volume levels for each item shown on the screen.
1. Select [Audio Tones] on the
[Common Settings] screen.
2. Use the scroll buttons to switch
between screens.
3. Perform the necessary
operations.
4. Select [Close].
To Next Page
Loading...
Need help?
General
