Storing and Handling Paper
173
Storing and Handling Paper
Always use high-quality, xerographic-grade paper in the machine. Damaged, curled, or
damp paper can cause jams and image quality problems. Follow these simple rules to
store paper.
• Store paper in dry conditions, away from extreme heat or cold, such as radiators or
open windows.
• Store paper flat on a shelf or pallet above floor level.
• Leave the paper wrapped and boxed until ready to be used.
• Re-wrap partly used packages of paper.
NOTE: Paper should not be stored in the paper trays.
Supported Paper Sizes and Types
This section lists the sizes and types of paper that can be used with the machine.
Supported Paper Sizes
The following table lists the paper sizes supported for each paper tray, duplex module,
and the finisher.
NOTE: For the capacity of each tray, refer to Specifications in the Appendix chapter
on page 325.
Standard Sizes
NOTE: The standard sizes of paper that can be detected vary depending on the paper
size table specified by the System Administrator. For information on setting the paper
size table, refer to Paper Size Settings in the Setups chapter on page 188.
Paper Size
Dimensions
(mm)
LEF/SEF
Tray 1, 2/Tray 3, 4
(Two Tray Module)
Tray 3, 4
(TTM)
Tray 5
(Bypass)
Duplex
Module
Finisher
A6 105.0 148.0 LEF X X O X X
A5 148.0 210.0 SEF O X O O X
LEF X X O O X
A4 210.0 297.0 SEF O X O O O
LEF O OOOO
A3 297.0 420.0 SEF O X O O O
B6 128.5 182.0 SEF X X O O X
LEF X X O O X
B5 182.0 257.0 SEF O X O O X
LEF O OOOO
B4 257.0 364.0 SEF O X O O O
5.5 × 8.5” 139.7 215.9 SEF O X O O X
LEF X X O O X
To Next Page
Loading...
Need help?
General
