12 Setups
202
POP3 Server Settings
This feature allows you to set up the POP3 server settings, such as port number, IP
address, server name, and password.
1. Select [POP3 Sever Settings] on
the [Network Settings] screen.
2. Perform the necessary
operations.
3. Select [Close].
POP3 Server Setup
Select the method of specifying the POP3 server.
POP3 Server IP Address
Allows you to enter the IP address of the POP3 server in the form of vvv.xxx.yyy.zzz.
This entry is required only when selecting [By IP Address] on the [POP3 Server Setup]
screen.
POP3 Server Name
Allows you to enter the POP3 server name in the style of FQDN within a maximum of
64 characters. This entry is required only when selecting [By Server Name] on the
[POP3 Server Setup] screen.
POP3 Server Port Number
Allows you to enter the port number for the POP3 server communication within the
range of 1–65535.
POP3 Server Check Interval
Allows you to enter the interval to poll the POP3 server within the range of 1–120
minutes in 1-minute increments.
POP3 Server Login Name
Allows you to enter the user name used to log in to the POP3 server up to 64
characters.
POP3 Server Password
Allows you to enter the password used to log in to the POP3 server up to 36 characters.
POP Password Encryption
Allows you to specify whether or not to encrypt the log-in password using APOP.
To Next Page
Loading...
Need help?
General
