Fuji Xerox Document Centre 286 series User Manual

12 Setups
206
PostScript Memory
Allows you to change the PostScript memory capacity within the range of 8.00–96.00
MB in 0.25 MB increments using the scroll buttons. The currently available memory will
be displayed at the top of the screen with the following message: “Memory Available:
XXX MB.”
HP-GL/2 Auto Layout Memory
Allows you to change the capacity of HP-GL/2 auto layout memory within the range of
64–5,120 KB in 32 KB increments using the scroll buttons. The currently available
memory will be displayed at the top of the screen with the following message: “Memory
Available: XXX MB.”
NOTE: This setting cannot be adjusted if the hard disk is installed.
Receiving Buffer - Parallel
Allows you to change the input buffer memory capacity when using the parallel port
within the range of 64–1,024 KB in 32 KB increments using the scroll buttons. The
currently available memory will be displayed at the top of the screen with the following
message: “Memory Available: XXX MB.”
Receiving Buffer - USB
Allows you to change the input buffer memory capacity for USB interface within the
range of 64–1,024 KB in 32 KB increments using the scroll buttons. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”
Receiving Buffer - LPD Spool
Allows you to change the input buffer memory capacity for LPD interface. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”
Off
Allows you to change the memory capacity within the range of 1024–2048 KB in 32 KB
increments using the scroll buttons.
Memory
Allows you to change the memory capacity within the range of 0.50–32.00 MB in 0.25
MB increments using the scroll buttons.
Hard Disk
Specifies the spool location to the hard disk.
Receiving Buffer - NetWare
Allows you to change the input buffer memory capacity for NetWare interface within the
range of 64–1,024 KB in 32 KB increments using the scroll buttons. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”

Fuji Xerox Document Centre 286 series Specifications

General

Brand	Fuji Xerox
Model	Document Centre 286 series
Category	All in One Printer
Language	English