HP-GL/2 Emulation
339
Active Area
Determining
Command
161 0 (Default): Auto
1: PS
2: IW
3: IP
4: Adapted
When auto-scaling is in use, this sets the method for obtaining
the active coordinate area.
[Auto]...Determines any of the methods listed below: PS, IW, IP,
or Adapted.
[PS]…Area specified by the first PS command is to be a
rectangular area.
[IW]...Area specified by the very last IW command is to be a
rectangular area.
[IP]...Area which combines all the IP Commands is to be a
rectangular area.
[Adapted]...The maximum/minimum coordinates within the
areas and coordinates plotted using the drawing command, and
the maximum size of characters and line width specified in the
page, are used to calculate the rectangular area.
Paper Margin 162 0–99 (Default: 0): 0–99mm
Sets the paper margin when auto scaling is being used.
Image
Enhancement
163 0: Off
1 (Default): On
Sets whether to artificially increase the resolution of an image
and smooth its edges.
Stapling 164 0 (Default): None
1: Top Left
2: Top Double
3: Top Right
4: Left Double
5: Right Double
6: Bottom Left
7: Bottom Double
8: Bottom Right
9: Center
Sets the stapling position.
Manual Feed
Tray Check
Indicator
165 0: None
1 (Default): Yes
Pen Width
(No. 0–15)
800–
815
0–255 (Default: 3): 0–25.5 mm
Sets the width of the pen (thickness of the line).
Width units are 0.1mm. Can be set in steps of 0.1mm.
Parameter
Item No.
Value
To Next Page
Loading...
Need help?
General
