6.3 Running the Getting Started Wizard
Before configuring the network, work with your network administrator to determine
the network settings that will be required to properly integrate the ETERNUS
CS800 with your company’s network.
"Configuring General Network Settings" on page 116
"Network Page: Bonding Details" on page 118
"Configuring Interface Details" on page 120
"Configuring Interface IP Addresses" on page 120
"Configuring Interface Routing" on page 123
Configuring General Network Settings
Under General, enter the following network information as provided by your network
administrator (see "Network Page: General" on page 116):
Figure 81: Network Page: General
When entering IP addresses, never use an address that is in a reserved IP
address range. To see a list of reserved IP address ranges, click the quick tip icon
[?] located near the IP address field.
Hostname The hostname of the ETERNUS CS800.
The Hostname cannot be blank and must contain
only letters
[A–Z, a–z ], numbers [0–9 ], and hyphens [- ].
116 ETERNUS CS800
To Next Page
Loading...
