Virtual Tape Drive
Model
Select the tape drive model emulated by the virtual drives in
the partition. All virtual tape drives in a partition must be the
same model.
The following tape drive models are available:
l IBM LTO-1, LTO-2, LTO-3, LTO-4, or LTO-5
l HP LTO-1, LTO-2, LTO-3, LTO-4, or LTO-5
Number of Virtual Tape
Drives
Accept the default number of tape drives (based on model),
or enter the number of virtual tape drives in the partition.
If all tape drives are currently assigned to other partitions,
you must remove one or more tape drives from an existing
partition to make them available for use in a new partition.
Enable deduplication Select the check box to enable data deduplication. Fujitsu
Technology Solutions recommends that you enable data
deduplication to optimize disk usage.
Data deduplication is enabled by default. You cannot
enable or disable data deduplication after the partition
is added.
Enable Auto Export When a tape is moved from a Storage Slot to an I/E Slot,
depending on the Auto Export setting, the media: will be
removed from the virtual I/E slot, if Auto Export is enabled.
(default) will remain in the virtual I/E slot, if Auto Export is
disabled.
2. Click Add.
3. (Optional) To add additional partitions, repeat Steps 1–2.Click Next to continue.
ETERNUS CS800 157
8 Configuration Wizards
To Next Page
Loading...
