Fujitsu ETERNUS CS800 - Page 158

8.3 VTL Wizard
Figure 106: VTL Wizard: Add Partition
Step 3: Add Media
1. In the Partition drop-down box, select the partition where the media will be created (see
"VTL Wizard: Add Media" on page 159).
2. Under Add Contiguous Media, enter information about the media:
Initial Location The initial location for cartridges after they are created
(Storage Slot or I/E Slot).
You cannot create more cartridges than the number of
available slots in the initial location. For example, if 50
I/E slots are available, you cannot create more than
50 cartridges if the initial location is set to I/E Slot.
Number of Media The number of cartridges to create in the partition.
Starting Barcode The first barcode number in the cartridge sequence.
You can enter any alpha-numeric string for the starting
barcode. Subsequent barcodes are incremented
accordingly. For example, if you enter AA, the cartridges
are numbered AA0000, AA0001, AA0002, and so on. If you
enter a starting barcode with less than 6 characters, zeroes
are appended to the barcode to make it 6 characters long.
158 ETERNUS CS800