8.3 VTL Wizard
If you do not see the world wide name (WWN) of the host, make sure the host is
connected to a Fibre Channel port on the ETERNUS CS800 and click Discover
Remote Hosts again.
The Backpanel Locations section displays a graphical representation of the Fibre
Channel and Ethernet ports as they appear on the rear of the system.
An Active status indicates the host is currently logged on to one or more Fibre
Channel target ports.
2. Enter information about the host:
Remote Host WWPN Enter the World Wide Port Name (WWPN) of the host.
Alias Enter a descriptive alias for the host
3. Click Apply.
4. (Optional) To discover additional hosts, repeat Steps 1–3.
5. Click Next to continue.
Figure 108: VTL Wizard: Discover Remote Hosts
Step 5: Map Remote Hosts
1. Enter information about the host access group (see "VTL Wizard: Map Remote Hosts"
on page 161):
Group Name Enter a name for the group.
Partition Select the partition to associate with the group.
Remote Host Select the host (initiator) to associate with the group.
160 ETERNUS CS800
To Next Page
Loading...
