10.3 VTL Configuration
To allow multiple hosts to access devices that belong to the same partition, you must create
separate host access groups for each host.
To access the Remote Host Mapping page, on the Remote Host Access page, click the
Remote Host Mapping tab (see "Remote Host Mapping Page" on page 234).
Figure 153: Remote Host Mapping Page
Tasks
Use the Remote Host Mapping page to perform the following tasks:
l View information about existing host access groups (see "Remote Host Mapping And
Groups" on page 234).
l Add a new host access group to a partition (see "Adding a Remote Host Access Group"
on page 235).
l Edit properties for an existing host access group (see "Editing a Remote Host Access
Group" on page 236).
l Delete a host access group from a partition (see "Deleting a Remote Host Access
Group" on page 237).
Remote Host Mapping And Groups
The Remote Host Mapping & Groups section displays the following information for all host
access groups on the ETERNUS CS800:
Group Name The name of the group.
Remote Host The host (initiator) associated with the group.
Target Port The Fibre Channel port (target) associated with the group.
234 ETERNUS CS800
To Next Page
Loading...
