Fujitsu ETERNUS CS800 - Page 398

11.4 Receive VTL
l On the target system, delete the source system associated with the snapshot from
the list of allowed replication sources (see "Deleting a Replication Source" on page
279).
2. On the target system, select a snapshot in the Snapshots List and click Delete.
If you delete the last snapshot for a partition while replication for the partition
(to this target) is still enabled, any replicated data not yet protected by a
replicated partition is not deleted. To delete this data, on the source system,
disable replication for the partition before deleting the last snapshot.
3. Click Yes to confirm the action.
Recovery Jobs
The Recovery Jobs page allows you to view information about snapshot recover operations
that were previously completed.
To access the Recovery Jobs page, on the Receive VTL page, click the Recovery Jobs
tab (see "Recovery Jobs Page" on page 398).
Figure 251: Recovery Jobs Page
The Snapshot Recovery Jobs section displays the following information about recovery
jobs:
Original Partition Name The name of the partition the snapshot was created
from.
398 ETERNUS CS800