Fujitsu PRIMERGY TX100 S3 Maintenance Manual

TX100 S3 Upgrade and Maintenance Manual 125
Hard disk drives
I For further information, please refer to the "ServerView Suite RAID
Management" user guide, available online at http://manuals.ts.fujitsu.com
(EMEA market) or http://jp.fujitsu.com/platform/server/primergy/manual/
(Japanese market) or from the ServerView Suite DVD 2 supplied with
your PRIMERGY server.
7.4.3 Removing a 3.5-inch HDD
Ê Remove the HDD to be replaced from the server as described in section
"Removing 3.5-inch HDDs" on page 118.
7.4.4 Installing a 3.5-inch HDD
Ê Install the new HDD into the empty drive bay as described in section
"Installing 3.5-inch HDDs" on page 107.
7.4.5 Concluding steps
Perform the following procedures to complete the task:
Ê Close the side cover as described in section "Installing the side cover" on
page 58.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section "Connecting the server to the mains" on
page 59.
Ê Please observe the notes on RAID rebuild in section "Performing a RAID
array rebuild" on page 83.

Fujitsu PRIMERGY TX100 S3 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX100 S3
Category	Server
Language	English