266 Upgrade and Maintenance Manual TX100 S3
Accessible drives
12.4 Replacing accessible drives
12.4.1 Required tools
● Preliminary and concluding steps: tool-less
● Removing accessible drives: tool-less
12.4.2 Preliminary steps
Before replacing an accessible drive, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 69.
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section "Removing backup and optical disk media" on
page 70.
Ê Verify if your backup software solution requires preparative configuration
before starting the procedure as described in section "Verifying and
configuring the backup software solution" on page 71.
Ê Shut down the server as described in section "Shutting down the server" on
page 42.
Ê Remove the power cord from the cable tie and disconnect it from the system
as described in section "Disconnecting power cord" on page 43.
Ê Bring the server to its horizontal position.
Ê Open the side cover as described in section "Removing the side cover" on
page 45.
Upgrade and Repair Units (URU)
Average task duration: 15 minutes
To Next Page
Loading...
