TX100 S3 Upgrade and Maintenance Manual 85
Basic software procedures
5.2.13.1 After replacing / upgrading LAN controllers
Please note when re-using a replaced LAN controller:
Ê Confirm with the customer whether the LAN controller you have replaced
has been used as part of a LAN teaming configuration.
Ê If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility after replacing the LAN controller.
Ensure that the controllers have been assigned as primary or secondary
according to your requirements.
I For details, refer to the relevant LAN driver manual.
5.2.13.2 After replacing the system board
Ê Confirm with the customer whether the onboard LAN controller you have
replaced has been used as part of a LAN teaming configuration.
Ê If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility after replacing the system board.
I For details, refer to the relevant LAN driver manual.
To Next Page
Loading...
