TX100 S3 Upgrade and Maintenance Manual 155
Expansion cards and backup units
9.2.1.7 Concluding steps
Perform the following procedures to complete the task:
Ê Route the cable carefully and close the cable holders.
Ê Close the side cover as described in section "Installing the side cover" on
page 58.
Ê Reconnect all external cables to the replaced expansion card.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section "Connecting the server to the mains" on
page 59.
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section "Updating RAID controller firmware" on page 75.
Ê In order to configure an expansion card that has been installed or replaced,
the card’s Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section "Enabling Option ROM scan" on
page 76.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 82.
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN controllers" on page 85.
To Next Page
Loading...
Need help?
General